July 24, 2014

Two plate injection mold review

In this post i will show structure of two plate injection mold .

2 plate mold structure

+ Locate Ring.

Positioning injection mold and injection molding machine

Positioning the center of the Nozzle and sprue bush

local ring of injection mold

local ring of injection mold

 

+ Sprue Bush.

sprue bush of injection mold

sprue bush of injection mold

+ Top Clamping Plate.

Holds the fixed side of the mold to attached at the fixed plate of the injection machine. This plate will attach locate ring, bolt, and sprue bush.

+ Bottom clamping plate.

Hold the movable side of the mold such as: spacer block, support plate, cavity plate and ejector system to the movable platen of the injection machine.

+ Guide pin & guide bush.

guide pin & guide bush of injection mold

guide pin & guide bush of injection mold

+ Cavity plate.

Use for make appearance of product, it can attach runner system, guide pin, cooling system,…

+ Core plate.

Use for make structure of products, I can attach ejector system, cooling system,…

+ Slide core. It can be used for make undercut of products.

slide core of injection mod

slide core of injection mod

+ Support pillar.

+ Return pin.

+ Sprue lock pin.

Make undercut for sprue

Hold runner when mold open.

sprue lock pin of injection mold

sprue lock pin of injection mold

+ Ejector plate & stop pin.

Ejector plate:  Pushes the ejector pins and return pins, connected with ejector rods.

Stop pin:

ejector plate of injection mold

ejector plate of injection mold

+ Ejector pin. Pushes products go out to the mold

sleeve pin of injection mold

sleeve pin of injection mold

VN:F [1.9.22_1171]
Rating: 8.2/10 (6 votes cast)
VN:F [1.9.22_1171]
Rating: +1 (from 1 vote)
Two plate injection mold review, 8.2 out of 10 based on 6 ratings

Comments

  1. But, even after Jolie-Pitt lawyers wrote to the “News of the Globe”
    saying the story was false, the newspaper then published a second story saying the pair had
    been arguing over where the details they had separated
    had been leaked from.

    VA:F [1.9.22_1171]
    Rating: 0.0/5 (0 votes cast)
    VA:F [1.9.22_1171]
    Rating: 0 (from 0 votes)
  2. There may also be warping on woodwork and
    carpets if they are not dried properly. Obviously, the
    planet will have the most of the benefits from this going green campaign. Since mold needs moisture and dirt to grow, it will be usually found in those areas of your house where there
    is moisture or humidity in the air.

    VA:F [1.9.22_1171]
    Rating: 0.0/5 (0 votes cast)
    VA:F [1.9.22_1171]
    Rating: 0 (from 0 votes)

Speak Your Mind

*